The RT100 F rig was originally designed for stainless steel applications, but has since been widely used in a wide range of materials, including aluminum and alloy steel. The point geometry has a non-angular design of the broken edge, which works well in ductility materials, where continuous cutting edges are desirable. To add additional tool life, RT100 F drills create easy-to-manage chips that are easy to control and evacuate from a bit. This drill eliminates the need for time – spent drilling and parker cycles.
RT100 R RT100 R (abrasive material)
The patented point geometry design of RT100 R drill is designed to provide maximum tool life and performance in grinding materials. The drill was originally used to drill CGI and ADI materials and is also useful in cast iron and other abrasive materials. The cutting edge of the radius can also help eliminate the burr problem on the outlet hole. RT100 R drilling machine is applied to increase heat and wear resistance.
RT 100 S Steel processing
RT 100 S for complex machining of steel. Its high cutting value and consistent good hole quality give a deep impression. Because of the special microscopic geometry, a particularly stable and precise cutting edge is produced. The network of RT 100 and flute is very smooth, reducing the friction between bit and chip. Reduce the processing temperature and reduce the evacuation effect of the chip. Less cutting force. The characteristics of these tools lead to the maximum hole quality and tool life.
Carbide drill bit – RT100T
In deep hole deep hole application, the RT100 T drill developed by our company provides high penetration rate and spatial precision.
It also provides 5 different standard lengths (15xD, 20xD, 25xD, 30xD, and 40xD). These spiral tools replace expensive gun drills on CNC machines. The RT100 T drill creates a short uniform chip formation that allows for higher feed rates in a wide variety of materials, without requiring a lot of time. Suitable for nc machining center with over 200 psi coolant pressure. The RT100 T drill has a hardened handle, and we recommend using high quality hydraulic chuck to ensure the highest center and drilling efficiency.
All RT100 T RIGS require and initial test holes to help guide the drill. The standard m7 tolerance RT100 U type drill is used as test bit (1xD) for 140 point Angle. Enter RT100 T, slowly enter the test hole, and then set the pressure and speed of the coolant. When reaching the depth of the drill, close the speed and coolant and remove the tool. These operational parameters ensure maximum efficiency and tool life.